metal band sawing machine horizontal band saw saw belt stuffy vehicle skid or interrupted cutting fault and treatment measures

2022-09-05

The saw belt of the metal band sawing machine horizontal band saw will have the failure of boring wheel skid or interrupted cutting in the long working process.

The main reasons for the sawing machine to slip or interrupt cutting are as follows: the feed is too large; Overload protection over load is small; Saw belt tension is insufficient.

The treatment measures are: reduce the feed; Increase the excess load; Improve the tension.

Remove iron filings from the sawing machine after each day’s work. After the saw belt of the saw machine stops rotating, open the cooling water switch and clean the table with the cooling water spray gun. Once cleared, lower the saw to the lowest position.

SEND YOUR INQUIRY HERE

Get The Best Quote For Your Products

    We have tried to make this website comprehensive and factual.
    WONSTEN GROUP reserves the right to make changes at any time without notice, to price, color, material equipment, specifications, models, machine operation, tooling requirements and availability.